42.51"L Front / 44.09"L Rear Dakrova Steel Flat Fender Flares | For 1997-2006 Jeep Wrangler TJ LJ 2-Door, Textured Black

✅ COMPATIBLE: 1997-2006 JEEP WRANGLER TJ & LJ
Engineered exclusively for the TJ generation body style, including the long-wheelbase LJ models.
• 1997-2006 Jeep Wrangler TJ (2-Door)
• 2004-2006 Jeep Wrangler LJ Unlimited (2-Door)

❌STRICTLY EXCLUDES (Do NOT Buy):
• 2007-2018 Jeep Wrangler JK / JKU
• 2018+ Jeep Wrangler JL / JLU
• Older models (YJ, CJ)

Brand: DAKROVA®
Type: Fender Flares (Flat Plate Style)
Material: 1.5mm (0.059") Cold-Rolled Carbon Steel
Surface Finish / Color: Textured Matte Black Powder-Coated
Front Flare Dimensions: 42.51" L × 16.53" H × 4.92" W
Rear Flare Dimensions: 44.09" L × 17.91" H × 4.92" W
Coverage Width: Approx. 4.92" - 5.00" (at widest point)
Total Weight: 29.6 lbs
Installation Requirement: Drilling is REQUIRED
Key Benefits: Shatter-Resistant, Rust Prevention, Covers Scratches

Installation: Unpack and inspect front and rear fender flares plus full fastener kits before mounting. The factory vehicle reserves partial mounting holes; you may drill extra holes on the body for firmer installation according to actual demand. Match three sets of bolt, washer and nut combinations to fasten front fender flares onto wheel arches, tighten fittings progressively after position alignment. Mount rear fender flares following the identical installation workflow, then repeat all operations for the driver side to finish full installation. Prepare 8mm, 10mm, 14mm wrenches, 1/4 inch hex socket; a power drill with corresponding bits is required if additional hole drilling is needed. The whole installation normally takes around 1 hour with 2 to 3 workers, actual duration varies by operator's mechanical experience.

Notes: Fully read installation instructions and verify all accessories prior to construction; professional installation is highly recommended, especially for customized drilling work. Improper drilling may damage vehicle sheet metal and paintwork. Inspect and retighten mounting bolts periodically during daily vehicle use. This product is primarily designed for decorative wheel arch widening, and cannot deliver impact protection for the vehicle body. The manufacturer assumes no liability for personal injury, paint or sheet metal damage caused by unqualified drilling, incorrect bolt torque and neglected routine hardware maintenance.

2 × Front Flat Steel Fender Flares
2 × Rear Flat Steel Fender Flares
Mounting Hardware Set (Bolts, Washers, Nuts)
1 × Installation Instruction Manual

WARNING:This product can expose you to chemicals including lead and lead compounds, DEHP and bisphenol A (BPA) which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go towww.P65Warnings.ca.gov.