44.4" Front / 54.7" Rear Dakrova Heavy-Duty Fender Flares | For 2020-2024 Jeep Gladiator JT

✅ COMPATIBLE: 2020-2026 Jeep Gladiator JT (Pickup)
Engineered exclusively for the Jeep Gladiator JT truck bed and cab design. Fits all trims (Rubicon, Mojave, Sport, Overland, etc.) within these years.

• 2020-2026 Jeep Gladiator JT (4-Door Crew Cab)

❌ STRICTLY EXCLUDES (Do NOT Buy):
• Any Jeep Wrangler JL (The rear flares will NOT fit a Wrangler)
• Jeep Wrangler JK / TJ / YJ
• Note: Gladiator is 4-door only; any claim of "2-door Gladiator" is incorrect.

Product Type: Flat Steel Fender Flares (4-Piece Front & Rear Set)
Core Material: Heavy-Duty Carbon Steel
Exterior Finish: Electro-Galvanized E-Coating + Textured Powder Coat
Front Flare Dimensions: 44.4" L × 20.2" H × 5.9" W (Approx.)
Rear Flare Dimensions: 54.7" L × 20.6" H × 5.3" W (Approx.)
Integrated Lighting: Amber LED Turn Signals (Pre-installed on Front Flares)
Installation Method: Direct Bolt-On (Minimal Drilling Required)

Installation: Remove original factory inner fender liners and plastic retaining clips before installation. Mount rivet nuts at special side mounting positions with hand riveting tools. Fit rubber sealing strips along the edge of new fender flares first, align the fender flares with vehicle mounting holes, fasten upper and lower rows of mounting points step by step using hex bolts, split lock washers, flat washers and flange hex lock nuts; leave intermediate bolts loosely fastened during preliminary assembly, fully tighten all fasteners after all hole positions are aligned properly. Complete wiring connection for integrated indicator lights: connect black negative wire to factory black wire, red turn signal wire to factory white-yellow signal wire. Separate rear fender flares can be installed following the same mounting workflow.
Notes: Read all pre-installation guidance thoroughly before construction; professional installation is strongly recommended, especially for rivet nut installation, interior trim disassembly and electrical wiring work. Prepare 8mm, 10mm sockets, trim clip removal tools and hand riveting tools for operation. Check all hardware parts prior to installation, inspect and retighten mounting fasteners periodically in daily vehicle use. This product is designed primarily for decorative wheel arch modification, and cannot provide effective collision protection for vehicle body. The manufacturer shall not be liable for paint damage, sheet metal deformation, circuit faults or personal injury resulting from improper disassembly, unqualified riveting/wiring, incorrect bolt torque and lack of routine hardware maintenance.

2 × Front Flat Steel Fender Flares (with built-in LED Turn Signals)
2 × Rear Flat Steel Fender Flares
1 × Complete Hardware Mounting Kit (Bolts & screws)
1 × Installation Instruction Manual

WARNING:This product can expose you to chemicals including lead and lead compounds, DEHP and bisphenol A (BPA) which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go towww.P65Warnings.ca.gov.